I'm currently sitting in a dealership having the 2026 PHEV software recall performed at under 5000miles. I have some questions about what exactly it fixes. I tried describing to the service writer what I perceive as software errors, but he didn't seem to understand.
Since new, the battery health info screen (left dash) has always said health 100%, miles since last checked 40,xxx. I dont remember the exact number, but it never changes if I drive more and check again.
The center screen range display works as expected while there is battery range remaining Total 130 miles, Battery 30 miles, Gas 100 miles. As soon as the battery is flat, both battery and total display ---. It cannot calculate 100-0=100 and displays essentially an error.
As I put more miles on the car, a full charge is shown as a smaller and smaller segment of the battery range bar. Currently, 49miles of battery range(as good as it gets) is displayed as approximately 2/3 of the battery bar on the center screen. When new, 49miles was 3/3 of the bar.
These are very obvious mistakes and I'm surprised they made it out of the factory like that. Has anyone else experienced these? Will the recall fix them? I expect to know in about 3 more hours.
Also, about 5 miles away from the dealership, something happened that never had before. I was cruising 70 on the highway with adaptive cruise on. Maintaining distance to a car in front also doing 70. Suddenly my car braked hard automatically and displayed a brief message on the dash which I didn't have time to read. 70-30 in a few seconds while my foot was on the gas, no brake pedal. Then right back to normal, accelerating. No residual messages.
Edit: If it matters, there were 3 miles of EV battery range being displayed on center screen at the time of the automatic braking event. The car in front did not brake, there were no vehicles to the rear. My hand was on the steering wheel the entire time. But it has in the past asked me several times to take control of the wheel, while I was already holding the wheel. The message displayed this time was longer than that, and the first word began with "Ch". I told this to the service writer first because it seemed the most relevant.
When tech plugged into the car, there were no messages or codes set. So no idea why it suddenly braked. He said the software recall does not address that issue. They tell me that displaying --- for total range when gas range still exists is "normal" which is just weird. Nothing said about the wrong bar graph display, I may have forgot to mention that among the things. Nothing about the battery health 40,xxx miles except the tech was unable to find it. Nothing yet about update progress 3 hours 45 minutes in.
Since new, the battery health info screen (left dash) has always said health 100%, miles since last checked 40,xxx. I dont remember the exact number, but it never changes if I drive more and check again.
The center screen range display works as expected while there is battery range remaining Total 130 miles, Battery 30 miles, Gas 100 miles. As soon as the battery is flat, both battery and total display ---. It cannot calculate 100-0=100 and displays essentially an error.
As I put more miles on the car, a full charge is shown as a smaller and smaller segment of the battery range bar. Currently, 49miles of battery range(as good as it gets) is displayed as approximately 2/3 of the battery bar on the center screen. When new, 49miles was 3/3 of the bar.
These are very obvious mistakes and I'm surprised they made it out of the factory like that. Has anyone else experienced these? Will the recall fix them? I expect to know in about 3 more hours.
Also, about 5 miles away from the dealership, something happened that never had before. I was cruising 70 on the highway with adaptive cruise on. Maintaining distance to a car in front also doing 70. Suddenly my car braked hard automatically and displayed a brief message on the dash which I didn't have time to read. 70-30 in a few seconds while my foot was on the gas, no brake pedal. Then right back to normal, accelerating. No residual messages.
Edit: If it matters, there were 3 miles of EV battery range being displayed on center screen at the time of the automatic braking event. The car in front did not brake, there were no vehicles to the rear. My hand was on the steering wheel the entire time. But it has in the past asked me several times to take control of the wheel, while I was already holding the wheel. The message displayed this time was longer than that, and the first word began with "Ch". I told this to the service writer first because it seemed the most relevant.
When tech plugged into the car, there were no messages or codes set. So no idea why it suddenly braked. He said the software recall does not address that issue. They tell me that displaying --- for total range when gas range still exists is "normal" which is just weird. Nothing said about the wrong bar graph display, I may have forgot to mention that among the things. Nothing about the battery health 40,xxx miles except the tech was unable to find it. Nothing yet about update progress 3 hours 45 minutes in.
Last edited:







